Relay and Fuse Panel behind Left Instrument Panel

Relay and Fuse Panel behind Left Instrument Panel

Removing





- With ignition switched off, disconnect battery ground (ND) wire. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove driver's storage compartment.

- Remove screws - 2 -.

- Disengage retaining pin - 3 - of relay and fuse panel at side guide - arrow -.

- Remove relay and fuse panel - 1 -.

If necessary, proceed with work steps.

- Unclip the fuse panel.

- Unplug connectors.

- Disconnect relays and unclip respective relay carrier.

• The precise assignment of relay and fuse panel behind left instrument panel can be found in the applicable wiring diagram.

Installing





Install in reverse order of removal, observing the following:

- Engage retaining pin - 3 - of relay and fuse panel at side guide - arrow -.

- Install driver's storage compartment

- Connect battery. Required actions, refer to => [ To connect, connect terminal clamp of ground (GND) wire by hand to battery negative terminal and tighten nut. ] Battery, Disconnecting and Connecting.

Tightening Specifications