Sill Side Trim
Sill Side Trim
• The sill side trim panel can only be removed and installed with the seat installed.
• Removal and installation is the same on the driver and passenger seat.
Removal
CAUTION!
Follow the safety precautions for pyrotechnic components.
- Bring seat as far up as possible.
- Remove backrest adjustment wheel. Refer to => [ Backrest Adjusting Wheel ]. Backrest Adjusting Wheel
- Remove seat height adjustment handle. Refer to => [ Seat Height Adjustment Handle ]. Seat Height Adjustment Handle
- Remove the expanding rivets - 2 - for the sill side trim - 1 -.
• The illustration shows the expanding rivets on a power seat.
- Open clips - 4 - and - 5 -.
- Unclip trim - 1 - on retaining bracket - 3 -.
- Disengage trim in area of backrest adjustment wheel and seat anchor.
- Remove the trim forward from the retaining bracket.
• Ensure bracket - 2 - is not damaged when removing trim.
Seat with Four-Way Lumbar Support
- Disconnect the electrical connector - 4 - on the lumbar support adjusting switch - 1 -.
3 Retaining bracket
Continuation for All Seats:
- Remove the sill side trim - 2 -.
Installation
Installation is reverse of removal, but note the following:
CAUTION!
Follow the safety precautions for pyrotechnic components.
• Ensure the sill side trim engages correctly on the retaining bracket and the locking clips are closed.