Relay Carrier and Fuse Panel, Passenger Side
Relay Carrier and Fuse Panel, Passenger Side
Removing
- Switch off ignition and remove ignition key.
- Remove the passenger side footwell cover.
- Remove the bolt - A - and footwell vent air duct - B -.
- Remove the nuts - 3 and 4 - and bolt - 1 -.
- Remove the passenger footwell relay carrier and fuse panel baseplate - 2 - - arrow -.
Vehicles through 05.09
- Release the retaining springs - A arrows - and remove the vehicle electrical system control module (J519) - item 1 - upward out of the relay and fuse panel - arrow B -.
Vehicles from 06.09
- Release the spring - arrows A - and remove the vehicle electrical system control module (J519) to the left from the relay and fuse panel - arrow B -.
All Vehicles
- Unclip fuse panel on relay carrier.
- Detach relays and control modules and then unclip appropriate relay carrier.
Installing
• Tightening specification, refer to => [ Front Relay Carrier and Fuse Panel Assembly Overview ] Front Relay Carrier and Fuse Panel Assembly Overview.
Install in reverse order of removal, observing the following:
- Install the vehicle electrical system control module (J519). Refer to => [ Vehicle Electrical System Control Module ] Service and Repair.
- Install the footwell vent air duct.