Selector Mechanism Overview
Selector Mechanism Overview
1 Locking Ring
• Remove ball when removing
2 Spacer
3 Pressure Spring
4 Ball Guide
• Do not lubricate
5 Ball
• Do not lubricate
6 Insulation
• For the shift lever support => [ (Item 11) Shift Lever Support ]
• Do not lubricate
7 Bolt
• 23 Nm
8 Clamping Plate
• Do not lubricate
9 Gearshift Lever
• Offset faces toward rear
• Lubricate the guide and the gearshift lever stops; for the correct grease, refer to the electronic parts catalog ETKA
• Lubricate the contact surfaces for the joint => [ (Item 12) Joint Piece ]; for the correct grease, refer to the electronic parts catalog ETKA
10 Spacer Tube
• Lubricate the outer circumference; for the correct grease, refer to the electronic parts catalog ETKA
11 Shift Lever Support
• Removing and installing, refer to => [ Selector Mechanism ] Selector Mechanism
• Do not lubricate
12 Joint Piece
• Between the selector rod and shift lever
• Lubricate the contact surfaces for the gearshift lever; for the correct grease, refer to the electronic parts catalog ETKA
13 Bolt
• For the joint piece => [ (Item 12) Joint Piece ]
14 Bolt
• 23 Nm
15 Nut
• 10 Nm
16 Gearshift Rod
17 Push Rod
• With bolt and washers
18 Nut
• Always replace
• 20 Nm
19 Bolt
• 4 Nm
20 Gearshift Lever
• Insert so that master spline aligns with shift rod
• Lubricate if needed; for the correct grease, refer to the electronic parts catalog ETKA
21 Sealing Boot
22 Ball Socket
• Lubricate; for the correct grease, refer to the electronic parts catalog ETKA
23 Bearing Bushing
• To remove, remove clip => [ (Item 26) Clip ]
24 Connecting Rod
• To remove, remove clip => [ (Item 26) Clip ]
25 Bolt
• 20 Nm
26 Clip
27 Bolt
• 20 Nm