Input Shaft Seal

Input Shaft Seal

Special tools, testers and auxiliary items required

• Pulling Hook (T20143/1)

• Thrust Piece (T40008)

• Sealing grease (G 052 128 A1)

Procedure

• Transmission removed, refer of => [ Transmission, Removing ] Transmission, Removing.

- Remove the clutch slave cylinder with release bearing. Refer to => [ Slave Cylinder with Release Bearing ] Service and Repair.

- Pry out the shaft sealing ring for the input shaft using the (T20143/1).





• Do not damage the seal running surface on the input shaft.

- Fill space between sealing lip and dust lip - arrow - halfway with sealing grease (G 052 128 A1).





- Lightly oil outer circumference of new shaft seal.

- Drive in the shaft sealing ring using the (T40008) until it is flush.





- Install the clutch slave cylinder with the release bearing. Refer to => [ Slave Cylinder with Release Bearing ] Service and Repair.