Shift Lever and Shift Housing For Vehicles to VIN 8J-7-013000 Assembly Overview

Shift Lever and Shift Housing for Vehicles to VIN 8J-7-013000 Assembly Overview

• Grease bearing areas and slide surfaces with grease (G 000 450 02).





1 Retaining Washer

• Removing and installing

2 Bushing

3 Spring

4 Bushing

5 Bolt

• 6 Nm

6 Cover

7 Damper

• For spring - 18 -

8 Damper

9 Bearing Shell

10 Shift Lever Guide

11 Damping Washer

12 Gasket

• Between shift housing and floor

• Self-adhesive

• Adhere to shift housing

13 Selector Lever

14 Shift Housing

15 Bushing

16 Pivot pin

17 Guide Bushing

• Press onto selector housing

18 Spring

• Installing

19 Selector Bracket

20 Bolt

• 5 Nm

21 Gasket

• Replace

22 Base Plate

• Replace

• Bend open tabs to remove

23 Selector Cable

• Removing and installing, refer to => [ Shift Cable and Selector Cable ] Service and Repair

• Adjusting, refer to => [ Shift Mechanism, Adjusting ] Adjustments

24 Shift Cable

• Removing and installing, refer to => [ Shift Cable and Selector Cable ] Service and Repair

• Adjusting, refer to => [ Shift Mechanism, Adjusting ] Adjustments

25 Retaining Washer

• Replace

• Removing

26 Nut

• 8 Nm

• Quantity: 4

27 Bushing

• Only fits in one position

28 Retaining Washer

• Replace

Remove Shift Cable Lock Washer - A - and Selector Cable - B -.





- Lift up the tab with a screwdriver - arrow 1 - and press off locking washer - arrow 2 -.

Removing and Installing Lock Washer





- Hold shift lever - 2 - in position.

- Press spacer bushing - 3 - in direction of - arrow -.

- Remove the circlip - 1 -.

Installing Spring

- Insert the leg - A - of the spring into the guide - 1 - from above.





- Pull the leg - B - of the spring downward and lay it into the guide from below.

• To improve clarity, the selector bracket is removed.