Seat Belt Height Adjuster
Seat Belt Height Adjuster
1 Seat Belt Height Adjuster
Removing
- Remove lower A-pillar trim. Refer to => [ Lower A-Pillar Trim ] Lower A-Pillar Trim.
- Remove the rear bench seat. Refer to => [ Rear Bench Seat ] Rear Bench Seat.
- Remove sill panel trim. Refer to => [ Sill Panel Strip ] Sill Panel Strip.
- Press button - 5 - and slide belt height adjuster into bottom position.
- Remove upper B-pillar trim - 7 -. Refer to => [ Upper B-pillar Trim ] Upper B-pillar Trim.
- Remove the bolt - 3 -.
- Remove belt relay - 2 -.
- Remove the bolt - 4 -.
- Slide belt height adjuster - 1 - upward and remove it from side panel.
Installation
Installation is reverse of removal, but note the following:
• Replacement seat belt height adjusters are always in bottom locking position.
• If belt height adjusters that were removed are reinstalled, they should be brought into the bottom lock position.
• Button - 5 - in upper B-pillar trim - 7 - must not be pressed during assembly.
- Engage belt height adjuster - 1 - in side panel.
- Install bolt - 4 - and tighten to the specification.
- Install belt relay - 2 -.
- Guide slide - 6 - into profile - arrow - on belt height adjuster.
- Install upper B-pillar trim - 7 -.
- On a new belt height adjuster - 1 -, forcefully press slide - 6 - up (approximately 60 N). This removes seat belt height adjuster assembly anchorage.
- Perform a function check after installing upper B-pillar trim.
• Seat belt height adjuster must latch with a click in all 5 possible positions (and in top position too).
• Button - 5 - must return to upper position by itself after being pressed.
• Belt relay - 2 - must swing into vertical position or carrier direction by itself after tightening screw.
If any functions did not work, seat belt height adjuster assembly must be checked; height adjuster may need to be replaced.
2 Belt Relay
3 Bolt
50 Nm
• If seat belt height adjuster is being removed for accident repairs, replace screw
4 Bolt
21 Nm
• If seat belt height adjuster is being removed for accident repairs, replace screw
5 Button
6 Slide
7 Upper B-pillar Trim