Modular Wire Routing With Ridged Tube on Front Seat
Modular Wire Routing with Ridged Tube on Front Seat
• The wires between the seat pan and the connector station are inside a double-shell corrugated tube in the so-called modulate wiring routing.
Special tools, testers and auxiliary items required
• Trim Removal Wedge (3409)
Opening corrugated pipe and removing individual wire
• Follow all safety precautions when working on pyrotechnic components.
• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.
- Remove the front seat:
• Standard seat and Sport seat (manual). Refer to => [ Manual Standard Front Seat ] Manual Standard Front Seat.
• Standard and sport power seat, comfort seat and super sport seat. Refer to => [ Power Standard Front Seat ] Power Standard Front Seat.
- Attach the front seat to the (VAS 6136). Refer to => [ Front Seats, Installing on the ] Front Seats, Installing on the Fixture For Seat Repair (VAS 6136).
- Open the wiring bracket - 1 - using the (3409).
- Remove the wiring bracket from the corrugated pipe - 2 -.
• Replacing a faulty wire or opening the corrugated tube for the side airbag, refer to => Electrical System General Information 97 or => [ Front Thorax Airbag Igniter (N199)/(N200) ] Front Thorax Airbag Igniter (N199)/(N200).
Install individual wires and close corrugated pipe
Install in reverse order of removal. Note the following:
- When bundling and placing individual wires in the corrugated tube, make sure the wires are not twisted.
• Note the installation position of the two-part corrugated tube to the wiring harness and the position of the wiring bracket to the corrugated tube.
- The beginning of the corrugated tube - 4 - should be placed immediately after the clip - 2 - or cable tie around the wiring harness - 3 -.
- Make sure the two-part corrugated tube locks cleanly over entire length.
- After connecting both halves of the corrugated pipe, wiring bracket - 1 - should be positioned and clipped into place according to the illustration.
- Make sure the side - arrow A - of the cable bracket connects to the last rib - arrow B - on the corrugated pipe.
- Install the cable ties, wiring bracket and clips in the same positions as before removal.
• Make sure the connectors are installed all the way in and are secure.
Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.
- Connect the battery ground cable with the ignition turned on.
• If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again using the Vehicle Diagnostic Tester.