Radiator and Coolant Fan Assembly Overview
Radiator and Coolant Fan Assembly Overview
1 Coolant Fan Control (FC) Control Module (J293)
• Separate or connected to the Coolant Fan (V7), depending on vehicle equipment
• Separate Coolant Fan Control (FC) Control Module (J293), removing and installing, refer to => [ Coolant Fan Control Module ] Service and Repair
2 Bolt
• 4.5 Nm
3 Bolt
• 5 Nm
4 Fan rib
• Removing and installing: A4, together with the cooler, refer to => [ Cooler and Fan Shroud ] Cooler and Fan Shroud. For the A5, refer to => [ Fan Shroud ] Fan Shroud.
5 Coolant Fan (V7)
• Separate or connected to the Coolant Fan Control Module (J293), depending on vehicle equipment
• Removing and installing Coolant Fan (V7), refer to => [ Coolant Fan ] Coolant Fan
6 Bolt
• 3.5 Nm
7 Rubber buffer
8 Rubber bushing
• For radiator
9 Coolant hose
• Lift retaining clamp to remove
• Connect to radiator => [ Connect the coolant hose with the connector
coupling ]
10 O-ring
• Replace
11 O-ring
• Replace
12 Coolant hose
• Lift the retaining clamp to remove
• Connect to radiator => [ Connect the coolant hose with the connector
coupling ]
13 Coolant hose
• To coolant reservoir
14 O-ring
• Replace
15 Radiator
• Removing and installing: A4, together with the fan shroud, refer to => [ Cooler and Fan Shroud ] Cooler and Fan Shroud. For the A5, refer to => [ Cooler ] Cooler.
• After replacing, replace entire amount of coolant
16 Retaining pin
• Disengage and remove using screwdriver
17 Rubber buffer
18 Radiator bracket
19 Bolt
3.5
20 O-ring
• Replace
21 Coolant hose
• Lift the retaining clamp to remove
• Connect to the radiator => [ Connect the coolant hose with the connector
coupling ]
22 Coolant Fan 2 (V177)
• Not with the 400 W fan activation
• Separate or connected to the coolant fan control module, depending on vehicle equipment
• Removing and installing, refer to => [ Coolant Fan ] Coolant Fan
23 Bolt
• 5 Nm
Connect the coolant hose with the connector coupling
- Remove old O-ring - 2 - in the coolant hose - 3 -.
- Moisten new O-ring with coolant and install it in the coolant hose.
- Press coolant hose onto the connection - 1 - until it engages audibly.
- Press the coolant hose on again and pull to make sure the connection is engaged correctly.