Leak Detection Pump: Service and Repair

Leak Detection Pump

Removing





• All cable ties which are opened or cut open when removing, must be replaced in the same position when installing.

- Remove left rear wheel.

- Remove rear left wheel housing liner.

- Remove ventilation hose - 1 -.

- Remove nuts - arrows -.

- Disengage diagnostic pump with bracket.

- Disconnect electrical harness connector - 3 - with ignition switched off and free up wire - arrow -.





- Cut the cable ties - 1 - and disconnect the hose - 2 -.

Installing

• Assembly overview, refer to => [ EVAP Canister System/Leak Detection System Assembly Overview ] Service and Repair.

• Tightening specifications, refer to => [ Fastener Tightening Specifications ] Fuel Supply System - Fastener Tightening Specifications.

Installation is performed in the reverse order of removal, noting the following:

• Secure all hose connections with hose clamps appropriate for the model.

• During installation, the cable ties must be re-installed at the same location.

- Secure hose - 2 - to bracket of leak detection pump with cable tie - 1 -.