Power Take-Off Drive Chain

Power Take-Off Drive Chain

Special tools, testers and auxiliary items required

• Key (T40049)

• Locking pin (T40069)

• Locking Pin (T40071)

• Locating Pins (T40116)

Removing

• Transmission removed.

• Engine oil drained.


Risk of injury.

• The lock carrier must be installed and the torque support must be securely attached.

- Remove timing chain lower cover. Refer to => [ Lower Timing Chain Cover ] Lower Timing Chain Cover.


Danger of damaging the drive chain because the bolt thread is too long.

• Use bolts with a 22 mm maximum thread length - a - to attach the (T40049).

• If only longer bolts are available, then the bolt head must be installed in such a way so that thread length is still 22 mm only.








- Install the (T40049) with 2 bolts - arrows - on the back of the crankshaft.






- Remove the locking bolt - arrow - for the "TDC" marking crankshaft from the cylinder block.






- Rotate the crankshaft in the direction of engine rotation to "TDC".

- Install the (T40069) in the hole and tighten to 20 Nm. Turn the crankshaft - 1 - back and slightly to completely center the bolt, if necessary.






- Press the chain tensioner guide rail in direction of - arrow - and secure chain tensioner using a (T40071).







Risk of destroying due to reversed running direction on a used drive chain.

• Mark the drive chain running direction with arrows using paint for installation later. Do not mark the chain using a punch, notch or similar.

- Remove the bolts - 3 - and the balance shaft chain sprocket.

- Remove the bolts - 1 - and - 2 - and the chain tensioner with the chain.

Installing

• Tightening specifications, refer to => [ Timing Mechanism Drive Chain Overview ] Timing Mechanism Drive Chain Overview.

• Secure crankshaft - 1 - in "TDC" position using (T40069).






- Mount the chain tensioner together with the chain and the balance shaft sprocket.

- Lock the balance shaft in the "TDC" position with the (T40116).






• The slots in the balance shaft sprocket must be at the middle position in relation to the threaded holes of the balance shaft. If necessary, adjust chain by one tooth.

- Tighten the chain tensioner bolts.

- Install the chain sprocket bolts - 1 - loosely.

• It must still be possible to rotate the chain sprocket on the balance shaft and it must not tip.

- Remove the (T40071) to release the chain tensioner.

- Press against the chain tensioner guide rail - arrow - with screwdriver and simultaneously fasten the bolts - 1 - for sprocket.

- Remove the (T40116) from the balance shaft.

The rest of the installation is performed in reverse order of removal, noting the following:

- Install timing chain lower cover. Refer to => [ Lower Timing Chain Cover ] Lower Timing Chain Cover.

- Install the locking bolt "TDC" mark crankshaft. Refer to => [ Locking Bolt Mark
Crankshaft, Tightening Specification ] Service and Repair.

- Fill engine oil and check oil level.