Ignition Coil: Service and Repair

Ignition Coils

Special tools, testers and auxiliary items required

• Ignition Coil Puller (T40039)

Removing

- Remove the engine covers - 1 - and - 2 - upward.






- Remove the bolts - arrows -, remove the air guides - 1 - and - 2 -.






- Free up the fuel line - 4 - and hose connection - 1 - from the EVAP canister on the air filter housing and on the air guide tube.






- Remove the vacuum hose - 2 - from the air guide hose connection.

- Remove the air guide pipe by loosening the hose clamp - 3 - and opening the clips - arrows -.

- Remove the bolts - arrows - and disconnect the connectors on the ignition coils.






- Lay the electrical wiring harness down slightly.

• Ignore - 1 and 2 -.

Cylinder Bank 2 (left):






- Remove bolt - arrow -.

- Disconnect the electrical connector to the engine coolant level warning switch (F66) on the bottom of the coolant reservoir and lay the reservoir aside with the coolant hoses - 1 - and - 2 - attached.

- Remove the bolts - arrows - and disconnect the connectors on the ignition coils.






- Lay the electrical wiring harness down slightly.

• Ignore - 1, 2 and 3 -.

Continued for Both Sides:






- Remove the ignition coils with the (T40039).

Installing

• Tightening specifications, refer to => [ Air Filter Overview ] Service and Repair, => [ Ignition Overview ] Ignition Overview.

Installation is performed in reverse order.