Brake Light Switch: Service and Repair

Brake Light Switch

• Brake Light Switch must be removed for adjustment.

• To ensure sufficient secure seating and definite adjustment, the brake light switch may only be installed once.

Removing

- Remove the driver side storage compartment.

- Disconnect the connector.

- Remove the brake light switch by rotating it 45° toward the left.

Installing

Installation is the reverse of removal, with special attention to the following:

- Pull out the plunger of the brake light switch completely - arrow -.





• The plunger does not need to be pulled out before installing, depending on the version. This does not change the installation.

- Insert switch with tabs - 1 - and - 2 - in designated retainers in assembly opening.

• The brake pedal must not be actuated during installation.

• When installing the brake switch, the plunger adjusts itself automatically.

- Guide switch through hole, press the brake pedal and turn the switch 45° to the right.





- Connect the connector.

- Install driver side compartment.

After adjusting the brake light switch check whether the brake pedal is on the end stop (rest position).