E-Box Right Plenum Chamber
E-Box Right Plenum Chamber
Special tools, testers and auxiliary items required
• Pry Lever - Remove Outside Mirror (80 - 200)
Removing
- Remove wiper arms. Refer to => [ Windshield Wiper Arms ] Windshield Wiper Arms.
- With ignition switched off, disconnect battery Ground (GND) cable. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.
- Remove rubber seal - 1 - on plenum chamber cover.
- Remove plenum chamber cover - 2 -.
- Remove bolts - arrows - for cowl grille - 1 - at left and right.
CAUTION!
Danger of damaging the cowl grille.
• Coat the space between the windshield and the cowl grille with some soapy water.
- Carefully remove the cowl grille - 1 - starting at the edge of the glass from the windshield vertically.
E-Box Right Plenum Chamber, Old Version
- Remove bolts - arrows -.
CAUTION!
Pump-valve unit of heater (left in front of E-Box) heats up significantly during operation - danger of burns!
- Remove cover of E-Box in right plenum chamber.
- Carefully pry off mounting bracket - 3 - using screwdriver - arrows 1 and 2 - and remove engine control module from E-Box right plenum chamber.
• The engine control module remains connected to the wiring harness.
- Disconnect connector - 4 - from connector strip at rear and set wiring harness aside.
- Unclip suppressor - 5 - from bracket in E-Box right plenum chamber.
- Remove all electrical harness connectors - 2 - from main fuse panel - 1 -.
E-Box Right Plenum Chamber, New Version
- Release clips - arrows - and remove one (or two) engine control modules - 1 - and - 2 -.
• The engine control modules remain connected at wiring harness.
- Remove screws - arrows -.
CAUTION!
Pump-valve unit of heater (left in front of E-Box) heats up significantly during operation - danger of burns!
- Remove cover of E-Box in right engine compartment.
- Unclip suppressor - 5 - from bracket in E-Box.
- Disconnect electrical harness connector - 4 - at rear of connector strip.
- Remove electrical harness connectors - 2 - from main fuse panel - 1 -.
• Disregard item - 3 -.
All
- Release clips - arrows - and remove main fuse panel - 1 - from E-Box right plenum chamber.
- Release locking mechanisms - arrows - and pull secondary relay carrier in E-Box right plenum chamber off upward.
- Remove nuts - arrows - on E-Box right plenum chamber - 1 -.
- Lay wires at E-Box right plenum chamber aside using (80 - 200).
• For easier removal, use silicon-free lubricating spray.
- Remove E-Box right plenum chamber.
Installing
Install in reverse order of removal, observing the following:
- When attaching cover for E-Box right plenum chamber, make sure cover is engaged correctly in mounts and no electrical wires are jammed.
- Connect battery. Required actions => [ Vehicles with : ] Battery, Disconnecting and Connecting.
- Adjust wiper arms. Refer to => [ Windshield Wiper Arms, Adjusting ] Windshield Wiper Arms, Adjusting.
Tightening Specifications