Operation CHARM: Car repair manuals for everyone.

E-Box in Left Plenum Chamber






E-Box in Left Plenum Chamber

Removing

- Remove wiper arms. Refer to => [ Windshield Wiper Arms ] Windshield Wiper Arms.

- With ignition switched off, disconnect battery Ground (GND) cable. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove rubber seal - 1 - on plenum chamber cover.





- Remove plenum chamber cover - 2 -.

- Remove bolts - arrows - for cowl grille - 1 - at left and right.





CAUTION!
Danger of damaging the cowl grille.

Coat the space between the windshield and the cowl grille with some soapy water.

- Carefully remove the cowl grille - 1 - starting at the edge of the glass from the windshield vertically.

- Remove bolts - arrows -.





- Remove E-Box cover in left plenum chamber.

- Remove the bolts - arrows - and remove wiper frame completely.





- Disconnect electrical connector - 1 -.

- Release locking mechanisms - arrows - and pull fuse panel - 1 - and secondary relay carrier - 2 - upward in E-Box left plenum chamber.





- Disconnect the multi-pin connectors - 1 through 5 -.





- Remove nut - arrow - at B+ wire.

- Remove hood release cable at opening lever.





- Disengage engine wiring harness - 4 - at E-Box left plenum chamber - 1 -.

- Press cup seal - 2 - out of E-Box left plenum chamber and guide engine wiring harness out through opening.

- Remove nuts - arrows - and pull E-Box left plenum chamber off upward.

- Guide cable - 3 - for hood out of E-Box left plenum chamber.

Installing

Install in reverse order of removal, observing the following:

- When attaching cover for E-Box left plenum chamber, make sure cover is engaged correctly in mounts and no electrical wires are jammed.

- Connect battery. Required actions => [ Vehicles with : ] Battery, Disconnecting and Connecting.

- Adjust wiper arms. Refer to => [ Windshield Wiper Arms, Adjusting ] Windshield Wiper Arms, Adjusting.

- Install hood release cable at opening lever.

Tightening Specifications