Operation CHARM: Car repair manuals for everyone.

Relay and Fuse Panel in E-Box Left Plenum Chamber






Relay and Fuse Panel in E-Box Left Plenum Chamber

Removing

- Remove wiper arms. Refer to => [ Windshield Wiper Arms ] Windshield Wiper Arms.

- With ignition switched off, disconnect battery Ground (GND) cable. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove rubber seal - 1 - on plenum chamber cover.





- Remove plenum chamber cover - 2 -.

- Remove bolts - arrows - for cowl grille - 1 - at left and right.





CAUTION!
Danger of damaging the cowl grille.

Coat the space between the windshield and the cowl grille with some soapy water.

- Carefully remove the cowl grille - 1 - starting at the edge of the glass from the windshield vertically.

- Remove bolts - arrows -.





- Remove E-box cover in left plenum chamber.

- Release locking mechanisms - arrows - and pull fuse panel - 1 - and secondary relay carrier - 2 - upward in E-box left plenum chamber.





- Pull out relay and control modules, then unclip respective socket for electrical multi-pin harness connectors.

- Unlock the release and remove from the fuse carrier, if equipped.





- Remove fuses on fuse panel.

- Pull off retaining strip - 1 - for harness connectors - arrow - and remove harness connectors from connector socket.

For exact assignment of relay and fuse panel in E-Box left plenum chamber, refer to current wiring diagram.

Installing

Install in reverse order of removal, observing the following:

- Connect battery. Required actions => [ Vehicles with : ] Battery, Disconnecting and Connecting.

- Adjust wiper arms. Refer to => [ Windshield Wiper Arms, Adjusting ] Windshield Wiper Arms, Adjusting.

Tightening Specifications