Self-Leveling Suspension Control Position, Programming

Self-Leveling Suspension Control Position, Programming

Special tools, testers and auxiliary items required

• Vehicle diagnosis, testing and information system (VAS 5051 A)

- Connect (VAS 5051 A) and then perform vehicle-specific entry into Guided Fault Finding and select Go To button "function/component selection". Refer to => [ VAS 5051 Connecting and Selection Functions ] Scan Tool Testing and Procedures.

Then

- "Chassis"

- "34 - Level control".

- "01 - On Board Diagnostic (OBD) capable systems"

- "J197 - Level control system control module functions".

- "J197 - Adapting control position".

• If the control position was programmed on vehicles with lane assist, the directional stabilization assistance control module (J759) with integrated camera must be calibrated. Refer to => [ Lane Assist Calibration Procedure ] Lane Assist Calibration Procedure.