Speech Control System

Speech Control System

=> [ Speech Input Control Module, through 29 August 2008 ]

=> [ Speech Input Control Module, from 1 September 2008 ]

Speech Input Control Module, through 29 August 2008

• If control module is replaced, select "Replacement" function for appropriate control module in "Guided Fault-Finding" routine. Use the Vehicle Diagnosis, Testing and Information System (VAS 5051) to do so.

- Switch off all electrical consumers.

- Remove the key.

Removing

- Remove radio (R). Refer to => [ Radio, Standard and BOSE Sound Systems, through MY 05 ] Radio System.

- Open cover - 2 - of radio and fold it down - arrow -.





- Carefully pull speech input control module (J507) - 1 - out of radio in - direction of arrow -.

Installing

- Install in reverse order of removal.

- Make sure that harness connector between speech input control module and radio engages correctly in radio.

Perform the following function test:

- Switch on the radio.

- Briefly depress PTT button on multi-function steering wheel.

A "Ping" tone sounds, the speech input system is active.

- Say "Help".

Since the radio is active, the speech dialog system responds with "Commands for the radio are...".

Depending on the equipment, other functions can be selected:

- If a telephone is installed, say "telephone".

The speech dialog system switches to the telephone mode.

- Press and hold the PPT button for approximately one second.

The speech dialog system responds with "Cancel" and is deactivated.

Speech Input Control Module, from 1 September 2008

• The voice control system is part of the information electronics control module 1 (J794) inside the glove compartment. It cannot be replaced alone.

• If it is faulty, then the information electronics control module 1 must be replaced.

- Switch off all electrical consumers.

- Remove the key.

• If control module is replaced, select "Replacement" function for appropriate control module in "Guided Fault-Finding" routine. Use the Vehicle Diagnosis, Testing and Information System (VAS 5051) to do so.

Removing

- Remove the information electronics control module 1. Refer to => [ Information Electronics Control Module 1, from 1 September 2008 ] Communication System.

Installing

- Install the information electronics control module 1. Refer to => [ Information Electronics Control Module 1, from 1 September 2008 ] Communication System.

Perform the following function test:

- Switch on the radio (R).

- Briefly depress PTT button on multi-function steering wheel.

A "Ping" tone sounds, the speech input system is active.

- Say the command "Help"

Since the radio is active, the speech dialog system responds with "Commands for the radio are...".

Depending on the equipment, other functions can be selected:

- If a telephone is installed, say "telephone".

The speech dialog system switches to the telephone mode.

- Press and hold the PPT button for approximately one second.

The speech dialog system responds with "Cancel" and is deactivated.