Right Instrument Panel Fuse Panel

Right Instrument Panel Fuse Panel

Removing





- With ignition switched off, disconnect battery ground (ND) wire. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove glove compartment.

- Remove bolts - 1 - of fuse panel - 2 -.

- Release the tabs and remove the fuse panel from the instrument panel central tube.

- Cut cable tie - 1 -.





- Release cover for fuse panel - arrows -.

- Remove fuses on fuse panel.

- Remove retaining strip for the connectors - arrows - and remove the connectors from fuse panel.





- Unclip socket - 1 -.

Installing

Install in reverse order of removal, observing the following:

• Attach all cable ties at the same locations when installing.

- Install glove compartment.

- Connect battery. Required actions, refer to => [ To connect, connect terminal clamp of ground (GND) wire by hand to battery negative terminal and tighten nut. ] Battery, Disconnecting and Connecting.

Tightening Specifications