Rear Door Window Motor: Service and Repair

Rear Door Motor for Window Regulator

Removing

- Door trim removed.

• The power window motor can be removed or installed with the motor or side window in any position.

• Before removing motor, disconnect electrical harness connectors.

- Remove Torx bolts - 2 - (T30) and remove motor.





Installation

- When installing, make sure that threaded pins - arrows - are engaged in inner door plate.

- Slide on window regulator motor - 3 - and secure with bolts - 2 -.

- Tightening specification 3.5Nm

• Only switch ignition on and off after installing motor and connecting wires.

• Then move door window upward to stop and keep pressing switch for window regulator for approximately 2 seconds longer.

• This position is the base position and the high- and low-running function is activated.