Right Cylinder Head Cover

Right Cylinder Head Cover

Special tools, testers and auxiliary items required

• Ignition Coil Puller (T40039)

Removing

- Remove the engine covers - arrows -.






- Remove the air filter housing.

- Remove the bolts - arrows - and disconnect the electrical connectors to the ignition coils on the right cylinder head.






- Disconnect the electrical connector - 5 - on the Camshaft Position (CMP) sensor 3 (G300).






- Press the connector release catches and disconnect the connector - 1 - on the camshaft adjustment valve 1 (N205) and camshaft adjustment valve 1 (exhaust) (N318).

- Press the electrical wiring harness to the side.

• Ignore - 2, 3 and 4 -.

- Remove the ignition coils with the (T40039).







Risk of violating emissions legislation.

• Do not open the hose connection - arrow -.








- Remove the bolts in the following sequence - 12 to 1 - and lay the right cylinder head aside with the crankcase ventilation hose - arrow - connected.

Installing

Install in reverse order, paying attention to the following:

• Replace the O-ring.

• Replace the cylinder head seal if it is damaged.

• Replace the cylinder head cover bolts when replacing the damaged seal.

- Clean the sealing surfaces; they must be free of oil and grease.

- Tighten the right cylinder head cover bolts. Refer to => [ Right Cylinder Head Cover, Tightening Specifications and Sequence ] Cylinder Head Overview.

- Install the air filter housing.