Wiring Harness In Transmission

Wiring Harness in Transmission

Removing


There is a risk of destroying the transmission control module (Mechatronic) with static discharge.

• Always discharge static by touching a grounded object, for example, vehicle ground, before touching or removing the Mechatronic unit.

• Never touch contacts in 16-pin connector, as the static charge could destroy the control module and thus the Mechatronic unit.

- Remove the Mechatronic. Refer to => [ Mechatronic Unit ] 0B6A Automatic Transmission.

- To discharge static electricity, touch the transmission housing (without wearing gloves).

- Disconnect the connector on the transmission by rotating screw connections counter-clockwise - arrow -.






- Remove the wiring harness clip - A -.






• Ignore - arrows -.

- Press the wiring harness connector - B - into the transmission and remove the wiring harness.

Installing

Install in reverse order, paying attention to the following:

- Replace wiring harness connector O-rings and lightly coat with ATF.

- Insert the wiring harness connector into the transmission housing while following the installation position.

- Install the clip - A - on the wiring harness connector - B -.






- Install the Mechatronic. Refer to => [ Mechatronic Unit ] 0B6A Automatic Transmission.