Tunnel Crossmember

Tunnel Crossmember

Special tools, testers and auxiliary items required

• Engine/Transmission Jack (V.A.G 1383 A)

• Final Drive Support (T10337)

Removing

- Remove the rear noise insulation - 2 -. Refer to => Body Exterior 66 Description and Operation.





- Mount the Gearbox Support (T10337) on the Engine/Transmission Jack (V.A.G 1383 A) and attach it to the bottom of the transmission.





- Raise transmission slightly.

CAUTION!
There is the risk of an accident.

• The Engine/Transmission Jack (V.A.G 1383 A) may only be used during assembly and must not sit unsupervised under the vehicle.

- Remove tunnel crossmember bolts - arrows -.





- Remove nuts - arrow - and the tunnel crossmember.





Installing

Install in reverse order, paying attention to the following:

• Tightening specifications. Refer to => [ Tunnel Crossmember, Transmission Mount and Transmission Support Assembly Overview ] 0B5A Automatic Transmission.

- Install the noise insulation. Refer to => Body Exterior 66 Description and Operation.