0B5A Automatic Transmission

Shift Lock Solenoid

Removing

- Place selector lever in position "P".

- Remove front ashtray.





- Loosen the nuts - 1, 3, 5 and 6 - several turns but do not remove them completely.





• This lowers the shift mechanism function unit slightly for better accessibility.

CAUTION!
The shift mechanism can be destroyed by broken retaining clips, tabs or other objects.

• Make sure no components or other objects fall into the shift mechanism. The shift mechanism must be replaced if that happens.

- Release the retaining tabs - 2 - and - 3 - in direction of - arrow - and raise the front of the cover - A - slightly and hold it in that position.





• This prevents the retaining tabs from engaging again.

- Using a screwdriver, release the upper retaining tab - 1 - on the cover in direction of - arrow - over the bracket - B - and remove the cover - A - upward.

- Disconnect electrical connector on the Shift Lock Solenoid (N110).





- Push hook - A - in direction of - arrow - and hold it.

• Replace the shift mechanism function unit if a retaining hook - A - is broken off.

- Tip Shift Lock Solenoid (N110) down and out in direction of - arrow - so the ball head - 1 - disengages from the operating lever on the shift mechanism.





- Remove Shift Lock Solenoid (N110).

Installing

Install in reverse order, paying attention to the following:

• Tightening specification. Refer to => [ Selector Mechanism Assembly Overview ] Selector Mechanism Assembly Overview.

- Rotate the ball head - 1 - into the correct installation position.

- Guide the Shift Lock Solenoid (N110) diagonally from above into the shift mechanism and tilt the bottom opposite direction of - arrow -.

• The ball head - 1 - must engage completely in the operating lever on shift mechanism. Press it down using a small screwdriver if necessary.





- Secure the Shift Lock Solenoid (N110) on the retaining hooks - A -.

- Place the cover - A - over the Shift Lock Solenoid (N110) and carefully let it engage - 1 through 3 -.





- Connect electrical connectors.

- Check the shift mechanism function before completing assembly. Refer to => [ Selector Mechanism, Checking ] Component Tests and General Diagnostics.

- Install front ashtray.