Condensation Water Drain
Condensation Water Drain
• The condensation water drain is installed in area of left rear fender and can be checked from outside without having to remove the components for it.
Checking
- Check valve - A - from below (with vehicle on a lift). Valve must not be obstructed by wax or underbody sealer and must close properly.
- Check condensation water drain of rear heating & A/C unit - F - for soiling (for example, using a piece of wire) and clean it if necessary.
• Condensation water hose - D - must fit securely on connection of heating & A/C unit - F -.
• Condensation water hose - D - to valve - A - must not be kinked or pinched.
• Depending on production time period, condensation water hose - D - is secured by a hose clamp - E - or a cable tie to condensation water drain of rear heating & A/C unit - F -.
Removing
- Switch off ignition.
- Slide condensation water drain - B - into vehicle interior from below (disengage condensation water drain - B - from rear floor plate - C - to do so).
- Bring rear heating & A/C unit into service position, refer to => [ Rear Heating & A/C Unit, Bringing Into Service Position ] Rear Heating & A/C Unit, Bringing Into Service Position.
- Disconnect condensation water drain hose - A - from condensation water drain of heating & A/C unit - D -.
• Depending on production time period, condensation water drain hose - A - is secured by a hose clamp or a cable tie to condensation water drain of heating & A/C unit - D -.
Installing
- Secure condensation water drain hose - A - using a hose clamp - B - to condensation water drain of heating & A/C unit - D -.
- When installing heating & A/C unit, make sure that condensation water drain is guided into opening - C - of floor plate.
- Install heating & A/C unit and other removed components.
- Pull condensation water drain hose - A - outward from below through opening in rear floor plate - C -.
- Secure condensation water drain hose - B - on rear floor plate - C - from below as depicted, make sure that condensation water drain hose is not twisted when doing this.