Cable Operating Lever

Cable Operating Lever

Special tools, testers and auxiliary items required

• Trim removal wedge (3409)

Removing





Proceed as follows:

- Release the engine compartment lid.

CAUTION!
There is a risk of damaging the operating lever mount.

• Do not remove the operating lever at an angle or tilt it.

- Carefully pry the operating lever horizontally out of its mount - arrow - using a trim removal wedge (3409).

Installing





Installation is reverse of removal, but note the following:

- Check the securing clip mount on the retainers - 1 - and the mount on the retainers - 2 - for damage. Replace the mount if the retainers are damaged.

- Insert the operating lever approximately halfway into the mount and pull it back.

- Carefully press the operating lever into the mount as far as the stop and guide it into the guide in the lower A-pillar trim.