Intake Manifold Assembly Overview

Intake Manifold Assembly Overview






1 Change-Over Roller

2 Bearing Bushing

3 O-ring

• Replace

4 Bolt

5 Bearing Cap

6 Intake Manifold

7 Bolt

• 20 Nm

8 Bolt

• 20 Nm

9 Seal

10 Connection for Crankcase Ventilation

• With Positive Crankcase Ventilation (PCV) Heating Element (N79)

11 O-ring

12 Throttle Valve Control Module (J338)

• Removal and installation, refer to => [ Throttle Valve Control Module ] Throttle Valve Control Module

13 Bolt

• 10 Nm

14 Bolt

• 20 Nm

15 Heat Shield for Exhaust Manifold

• With intake manifold support

16 Gasket

• Replace

• Insert in intake manifold

17 Bolt

• 13 Nm

18 Bolt

• 10 Nm

19 Vacuum Actuator

• For intake manifold flaps

• Checking, refer to => [ Intake Manifold Flap Vacuum Actuator, Checking ] Testing and Inspection

• Removal and installation, refer to => [ Intake Manifold Flap Vacuum Actuator ] Service and Repair

20 Low Pressure Connection

• To Intake Manifold Tuning (IMT) Valve (N156)

21 O-ring

• Replace

22 Bearing Bushing

Engine Lifting Eye on the Cylinder Head - Tightening Specification





Tighten bolts - arrows - to 20 Nm.

Oil Dipstick and Vacuum Reservoir - Tightening Specifications





Tight the bolts - 3 - and - 4 - to 5 Nm.