Input Shaft, Output Shafts, Differential, Bevel Box and Selector Rods Assembly Overview

Input Shaft, Output Shafts, Differential, Bevel Box and Selector Rods Assembly Overview






1 Output Shaft, 1st to 4th Gears

• Disassembling and assembling, refer to => [ Output Shaft, 1st to 4th Gears ] Output Shaft, 1st to 4th Gears

• Installation location

2 Selector Rod with Shift Fork for 1st and 2nd Gear

• Installation location

3 Selector Rod with Shift Fork for 3rd and 4th Gear

• Installation location

4 Output Shaft 5th/6th Gear/Reverse Gear

• Disassembling and assembling, refer to => [ Output Shaft for 5th/6th Gear and Reverse Gear ] Output Shaft For 5th/6th Gear and Reverse Gear

• Installation location

5 Selector Rod with Shift Fork for 5th and 6th Gear

• Installation location

6 Reverse Gear Shift Fork

• Installation location

7 Input Shaft

• Disassembling and assembling, refer to => [ Input Shaft ] Input Shaft

• Always replace grooved ball bearings on input shaft - 6 - => [ Grooved Ball Bearing ] Input Shaft Assembly Overview

8 Reverse Shaft

• With thrust washer

9 Thrust Washer

10 Bleeder

• Connect to clutch slave cylinder - 14 -

11 Clutch Housing

12 Input Shaft Seal

• Replace, refer to => [ Input Shaft Seal ] Input Shaft Seal

13 O-ring

• Always replace

• Pull onto line connection

• Coat with brake fluid before installing

14 Clutch Slave Cylinder with Release Bearing

15 Bolt

• Tightening specification - 1 - Clutch Release Mechanism, Clutch Slave Cylinder Assembly Overview

16 Bolt

• Tightening specification - 13 - => [ Bolt ] Flange Shaft and Seals on Bevel Box Assembly Overview

17 Bolt

• Replace

• 40 Nm

• Quantity: 4

18 Bevel Box

• Removing and installing with transmission installed, refer to => [ Bevel Box, Removing ] Bevel Box, Removing

• Removing and installing with transmission removed, refer to => [ Transmission without Circlip A for Cap/Input Shaft ] Transmission Without Circlip A For Cap/Input Shaft

19 Differential

• Disassembling and assembling, refer to => [ Differential ] Service and Repair

Installation Position of Shafts and Selector Rods in Transmission





1 Input Shaft
2 Output Shaft, 1st to 4th Gears
3 Output shaft 5th/6th and reverse gear
4 Reverse Shaft
A Selector rod for 3rd and 4th gear
B Selector rod for 1st and 2nd gear
C Selector rod for 5th and 6th gear
D Reverse gear shift fork 1)

1) From transmission build date 5/25/09, bearing on the selector rod for the shift fork for 5th and 6th gear - C -. Difference, reverse gear shift forks => [ Reverse Gear Shift Fork Differentiation ] Shift Forks Assembly Overview