Transmission Mount, installing

Transmission Mount, installing

Installing

• Tightening specifications, refer to => [ Subframe Mount Assembly Overview ] Description and Operation.

Install in reverse order, paying attention to the following:

- First install transmission bracket on transmission - arrows -.





- Raise transmission with engine support bridge (10 - 222 A) spindle until transmission bracket - 1 - touches transmission mount support arm - 2 -.





- Next install bolts - arrows - but only tighten by hand.

Risk of damaging threads in transmission mount support arm due to bolts inserted crooked.

• Before installing bolts - arrows -, transmission bracket - 1 - and transmission mount support arm - 2 - must be absolutely parallel to each other. If necessary, raise rear of transmission with trolley jack.

- Only tighten bolts if subframe is installed.

- Remove (10 - 222 A) from engine.

- Install the air filter housing.