Speech Input Control Module (J507) Through 10.31.2008

Speech Input Control Module (J507) through 10.31.2008

The speech input control module is located in the radio (MMI) behind the luggage compartment left side trim.

- Turn off all electrical consumers.

- Remove the key.

- If control module is replaced, select "Replacement" function for appropriate control module in "Guided Fault Finding".

Use the Removal and Installation.

Removing

- Remove the radio (MMI). Refer to => [ Radio, MMI through 10.31.2008 ] Radio, Multimedia, Navigation.

- Open cover - 2 - of radio and fold it down - arrow -.






- Carefully pull the speech input control module - 1 - out of the radio in the - direction of the arrow -.

Installing

- Install in reverse order of removal.

- Make sure that harness connector between speech input control module and the radio engages correctly in the radio.

Perform the following function test:

- Switch on the radio.

- Briefly depress PTT button on multifunction steering wheel.

A "Ping" tone sounds, the speech input system is active.

- Say "Help".

Since the radio is active, the speech dialog system responds with "Commands for the radio are...".

Depending on the equipment, other functions can be selected:

- If a telephone is installed, say "telephone".

The speech dialog system switches to the telephone mode.

- Press and hold the PPT button for approximately one second.

The speech dialog system responds with "Cancel" and is deactivated.