Fuel Injectors

Fuel Injectors

Special tools, testers and auxiliary items required

• Tool Set (T10133) with puller

• Removal Tool (T10133/16)

• Puller (T10133/2) was changed and is now called puller (T10133/2-A). If the new tool is not available, the old one can be modified.

Modify the T10133/2 to create the T10133/2-A.

- File the semicircle as shown in the illustration. The semicircle allows the tool to slide farther onto the fuel injector, thus providing the tool with a larger contact surface.

- Mark the modified tool with an "A" at the end of the tool number.






Special tools, testers and auxiliary items required

• Round file approximately 6 mm

Removing

- Remove the engine cover.

- Remove the intake manifold and the fuel rail (engine code CAEB). Refer to => [ Intake Manifold ] Intake Manifold.

Removing the fuel injectors, in the event that they are stuck in the fuel rail

Carefully pull the fuel injectors out of the fuel rail.

Removing the fuel injectors, in the event that they are stuck in the cylinder head

Fuel injector (old version)





1 Combustion chamber sealing ring (Teflon(R) sealing ring), replace, the ring must not be greased or handled with any other lubricants when installing.
2 The support ring is being replaced by an intermediate ring. See next illustration, refer to => [ Fuel Injector (new version) ]
3 Fuel injector
4 Spacer ring, replace if damaged
5 O-ring (replace, coat lightly with clean engine oil when installing)
6 Support ring (via this support ring, fuel rail utilizes the force to hold the fuel injector in place in the cylinder head).

Fuel Injector (new version)





1 Intermediate ring, replacing
2 Mount
3 Combustion chamber sealing ring (Teflon(R) sealing ring), replace, the ring must not be greased or handled with any other lubricants when installing.
4 Fuel injector
5 Spacer ring, replace if damaged
6 O-ring (replace, coat lightly with clean engine oil when installing)
7 Support ring (via this support ring, fuel rail utilizes the force to hold the fuel injector in place in the cylinder head).

- Cover open intake channels with a clean cloth.

- Disconnect electrical harness connector at fuel injector that is to be removed.

- Guide the (T10133/2A) in the groove on the fuel injector.






- Then position the (T10133/16) and remove the fuel injector by loosening the bolt - 1 -.

• The combustion chamber seal must always be replaced before installing the fuel injector. Refer to => [ Teflon(R) Combustion Chamber Seal ] Teflon(R) Combustion Chamber Seal.