Lock Trim, Without Lock Cylinder

Lock Trim, without Lock Cylinder

Special tools, testers and auxiliary items required

• Trim Removal Wedge (3409)

Removing






- Release the backrest.

- Make sure the button - 2 - is in the top position.

- Press the retaining tabs on both sides of the trim - 1 - in the direction of the - arrow - using the trim removal wedge (3409).

- Pull the front of the trim - 1 - as far up from the backrest - 3 - as possible.

- Using a flat-head screwdriver, pry the clip - arrow - located in the rear area of the trim - 1 - out of the retainer.






- Remove the trim upward from the backrest.

Installing






- Guide the front clips - arrow - under the cover.

- Make sure the cover is covered by the rear part of the trim - 1 -.

- Press the front of trim - 1 - down until the clips - arrows - engage audibly in the retainer.

- Press the section of trim - 1 - marked with an - arrow - down at an angle until the center rear clip engages audibly in the retainer.






• The illustration shows trim with a lock cylinder.

• The trim - 1 - is seated securely once it engages audibly with the retainer.

- Make sure the button - 2 - moves easily after installing the trim.