Fuel Level Sensor 1

Fuel Level Sensor 1

Removing

- Remove the rear engine cover - 2 - upward.






- Free up the fuel line - 4 - and hose connection - 1 - from the EVAP canister on the air filter housing and on the air guide tube.






- Remove the vacuum hose - 2 - from the air guide hose connection.

- Remove the air guide pipe by loosening the hose clamp - 3 - and opening the clips - arrows -.

- Disconnect the connector - 1 -.






- Open the locking mechanisms - arrows - and secondary air injection sensor 1 (G609) - 2 -.

Installing

Install in reverse order of removal. Note the following:

• Replace O-ring.

• The hose connections as well as the air guide pipes and hoses must be free of oil and grease before installing.

• Secure all hose connections with hose clamps appropriate for the model.

• In order to be able to securely mount the air guide hoses on their connectors, spray the screws on the previously used clamps with a rust remover.