Intake Manifold Overview

Intake Manifold Overview






1 - Bolt for Intake Air Temperature (IAT) Sensor (G42)

• 9 Nm

2 - Intake Air Temperature (IAT) Sensor (G42)

- Evaporative Emission (EVAP) Canister Purge Regulator Valve 1 (N80)

• With double check-valve, checking, refer to => [ Double Check-Valve, Checking ] Testing and Inspection

4 - Intake Manifold

• 10 Nm

• Removing and installing, engine codes CAEB and CPMA, refer to => [ Intake Manifold ] Intake Manifold

5 - Channel Separating Plate Vacuum Diaphragm (intake manifold flaps)

6 - Intake Manifold Runner Control (IMRC) Valve (N316)

7 - Fuel Injectors

• Replace the O-ring and Teflon(R) ring

• Note correct installation position

• Removing and installing, refer to => [ Fuel Injectors ] Fuel Injectors

8 - Intake Manifold Support

9 - Intake Manifold Support Bolt

• 23 Nm

10 - Intake Manifold Support Nut

• 10 Nm

11 - Throttle Valve Control Module (J338) Bolts

• 9 Nm

12 - Throttle Valve Control Module (J338) , Electronic Power Control (EPC) Throttle Drive (G186)

• EPC throttle drive angle sensor 1 (G187) and EPC throttle drive angle sensor 2 (G188)

• It is necessary to adapt the throttle valve control module (J338) to the Engine Control Module (ECM) (J623) whenever it is removed and installed or replaced. Use the vehicle diagnostic tester in "Guided Functions".

13 - Seal

• Replace