Fuse Panel B in Engine Compartment E-Box

Fuse Panel B in Engine Compartment E-Box

Removing






- Switch the vehicle ignition off.

- Disconnect the battery ground (GND) cable from the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.


Damaged high voltage components may produce dangerously high voltage.

Observe the following when working near or around high voltage components and cables:

• Do not use tools that have sharp edges, that are used for cutting or shaping, or that generate heat, such as welding, soldering, hot air or thermal adhesive equipment.


- Remove the washer fluid reservoir filler neck. Refer to => [ Washer Fluid Reservoir Filler Neck ] Washer Fluid Reservoir Filler Neck.

- Remove the screws - 1, 2 and 4 - and remove the engine compartment E-box cover - 3 - in the direction of the - arrow -.

• Disregard item - 5 - in this example.

- Release the retainers in the direction of the - A arrows - and remove the engine control module in the direction of the - B arrow -.






- Disconnect the electrical connector - 2 - if applicable.






- Disconnect the electrical connectors - 4 - and remove the electrical wire - 3 -.

- Release the retainers - arrow - and remove the fuse panel B - 1 -.

- Disengage engine wiring harness at electronics box and lay bare.

- Remove the electrical wire - 5 -.






- Remove the relay - 3 - and control modules - 4 - from the fuse panel B.

- Release the retaining clip - arrow -, push the fuse panel - 2 - back and out and disengage it.

- Release the retaining clip and press the auxiliary fuse panel - 1 - back and out.

- Release the retaining clips in the direction of the - arrows - and press the relay carrier - 2 - back and out of the bracket - 1 -.






- Remove the fuse panel B from the engine compartment E-box.

Installing

• Tightening specification, refer to => [ Engine Compartment E-Box, Wire Junction, Fuse Holder and Battery Overview ] Engine Compartment E-Box, Wire Junction, Fuse Holder and Battery Overview

Install in reverse order of removal, observing the following:

- Install the washer fluid reservoir filler neck. Refer to => [ Washer Fluid Reservoir Filler Neck ] Washer Fluid Reservoir Filler Neck.

- Connect battery. Required actions, refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.