Input Shaft, Output Shaft, Reverse Drive Gear and Shift Rails/Shift Forks Overview

Input Shaft, Output Shaft, Reverse Drive Gear and Shift Rails/Shift Forks Overview






1 Transmission Housing

• With differential and pinion

2 Input and Output Shafts with Shift Fork Group

• Disassembling and assembling, refer to => [ Shift Fork Group, Input Shaft, 1st, 2nd and Reverse Gear Output Shafts Overview ] Shift Fork Group, Input Shaft, 1st, 2nd and Reverse Gear Output Shafts Overview

3 Oil Catch Tray

• Gets clipped in to the bearing bracket

4 Reverse Drive Gear

• With the reverse shaft

• Reverse drive gear assembly overview; refer to => [ Reverse Drive Gear Assembly Overview ]

5 Oil Guide Element

6 Magnet

• Clean off

Reverse Drive Gear Assembly Overview





1 Reverse drive gear

Installed position: The shoulder faces the transmission housing.

2 Needle bearing
3 Reverse shaft support
4 O-ring
5 Reverse shaft

Slide the O-ring onto the circular groove, - arrow - item 4.

The threaded hole on the reverse shaft must line up down the center with the opening on the reverse shaft support.