Switch unit, Microswitch for Backrest Adjustment Assembly Overview

Switch unit, Microswitch for Backrest Adjustment Assembly Overview

• The 6-pin connector with backrest lock switch and backrest forward stop switch are not separate from the bracket. They are delivered as a microswitch with bracket switch unit - 7 -.

• The locking bushing - 6 - and screws for mounting the switch unit - 2 - are supplied as replacement parts.

• The backrest is shown without the upholstery, cover and seat pan.





1 Backrest frame

2 Bolt

• Quantity: 2

• 1.5 Nm

3 Window

4 Nut

• Tightening specification, refer to => [ (Item 2) Nut ] Backrest Adjustment Motor Assembly Overview

• replace

5 Shaft

• The threads must always be cleaned before installing the nut - item 4 -, for example, using a thread tap.

• Apply locking compound fluid (D 000 600 A2) to the threaded section of the shaft before installing the nut

6 Locking bushing

• Clipped to the spindle

• Clip to the spindle after adjusting the switch unit

7 Switch unit (microswitch with bracket)

• Removing and Installing, refer to => [ Backrest Adjustment Motor ] Backrest Adjustment Motor

• Adjusting, refer to => [ Switch Unit Microswitch, Adjusting ] Switch Unit Microswitch, Adjusting

• Checking, refer to => [ Switch Unit Microswitch, Checking ] Switch Unit Microswitch, Checking