Lane Change Assistance Control Module, 2-Door

Lane Change Assistance Control Module, 2-Door

Removing





- Remove rear bumper cover.

- Disconnect electrical connector - 3 -.

- Remove bolts - 2 - and - 4 -.

- Remove the lane change assistance control module - 1 - from the mount on the bumper.

Installing

Install in reverse order of removal, observing the following:

- Install the cover on the rear bumper.

If the bumper cover was removed, the lane change assistance control module (J769)/ (J770) must be calibrated again => [ Lane Change Assistance, Preparing for Calibration ] Lane Change Assistance, Preparing For Calibration.