Manual Standard Front Seat
Manual Standard Front Seat
• The following describes removing and installing the driver side. The procedure for the front passenger seat is similar.
Removing
Follow all safety precautions when working on pyrotechnic components. Refer to => [ Safety Precautions ] Service Precautions.
- Bring seat into service position. Refer to => [ Front Seats Service Position, Setting ] Front Seats Service Position, Setting.
- Turn on the ignition.
- Disconnect the ground cable from the battery.
Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.
- Disconnect the harness connectors> Refer to => [ Harness Connectors, Disconnecting and Connecting ] Harness Connectors, Disconnecting and Connecting on the connector station in the floor.
- Connect Airbag Adapter (VAS 6281). Refer to => [ Airbag Adapter VAS 6281, Connecting and Disconnecting ] Airbag Adapter VAS 6281, Connecting and Disconnecting.
- Remove front bolts - 1 - (quantity: 2).
3 Rear console
4 Front console
- Press the seat forward/back adjustment handle and move the seat - 2 - as far forward as possible.
- Remove rear bolts - 1 - (quantity: 2).
- With help from a second technician, lift the seat - 2 - out of the vehicle.
Installing
• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Safety Precautions ] Service Precautions.
• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.
Install in reverse order of removal. Note the following:
- Remove Airbag Adapter (VAS 6281) only after installing seat. Refer to => [ Airbag Adapter VAS 6281, Connecting and Disconnecting ] Airbag Adapter VAS 6281, Connecting and Disconnecting.
• Make sure the connectors are installed all the way in and are secure.
- Connect the connectors to the connectors of the connector station in the floor. Refer to => [ Harness Connectors, Disconnecting and Connecting ] Harness Connectors, Disconnecting and Connecting.
Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.
- Connect the battery ground (GND) cable with the ignition turned on.
• If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again using the vehicle diagnostic tester.
For the correct tightening specifications, refer to => [ Manual Front Seat Overview ] Manual Front Seat Overview.