Outer Tail Lamps

Outer Tail Lamps

Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Service Precautions.

Removing





- Switch off ignition and remove ignition key.

- Turn light switch into 0 position.

- Open the luggage compartment side trim cover.

- Remove the threaded pins - 2 -.

- Pivot the tail lamp - 1 - outward - arrow - and disengage retaining pins from the body.

- Disconnect the electrical connector.

Installing

• Tightening specification, refer to => [ LED Outer Tail Lamps Assembly Overview ] LED Outer Tail Lamps Assembly Overview.

Install in reverse order of removal, observing the following:

• The self-adhesive seal on the tail lamp housing must seal correctly.

- Position the tail lamp on the body and press the retaining pins into the holes.

- Tighten the threaded pins.