Transmission Output Shaft Seal With Splines, Replacing, Vehicles Without Vibration Damper on the Transmission Output Shaft

Transmission Output Shaft Seal with Splines, Replacing, Vehicles without Vibration Damper on the Transmission Output Shaft

Special tools, testers and auxiliary items required

• Pulling Hook (T20143)

• Oil Seal Installing Tool (T40239)

• Guide Sleeve (T40239/1)

• Sealing grease (G 052 128 A1)

Procedure

- Remove the driveshaft.

- Pry off the dust ring - 1 -.






• The dust ring cannot be removed without destroying it.

- Shaft seal, transmission output shaft with splines, removing.






- Clean the running and sealing surface.

- Coat the outer edge of the shaft seal with transmission fluid.

- Mount the (T40239/1) , - 1 - on the transmission output shaft.






- Fill the space between the sealing and dust lip half way with sealing grease (G 052 128 A1).

- Install the shaft seal - 2 - over the guide sleeve - 1 - and onto the transmission output shaft.

• Installed position: The open side of the seal faces the transmission housing.

- Install the shaft seal using the (T40239) , - 1 - from the (T40239) up to the end stop. Do not bend the seal.






• Remove the (T40239/1) from the shaft seal carefully so that the sealing lip does not fold over.

- Install a new dust ring - 1 -.






- Install the driveshaft.

- Transmission fluid level, checking. Refer to => [ Transmission Fluid Level, Checking ] Service and Repair