Operation CHARM: Car repair manuals for everyone.

Left and Right Rear Multi-Contour Seat Compressor V441/V442/Driver and Passenger Side Rear Multi-Contour Seat Control Module







Left and Right Rear Multi-contour Seat Compressor V441/V442/Driver and Passenger Side Rear Multi-contour Seat Control Module J875/J874

Includes Left Rear Multi-contour Seat Compressor (V441) / Driver Side Rear Multi-contour Seat Control Module (J875) / Right Rear Multi-contour Seat Compressor (V442) / Passenger Side Rear Multi-contour Seat Control Module (J874)

Removing

Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and Testing Procedures ] Description and Operation.

Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Remove the multi-contour seat. Refer to => [ Multi-contour Seat ] Multi-Contour Seat.

- Disconnect the connector - 3 -.






- Remove the compressor- 2 - sideways out of the rubber buffers (4 pieces) - arrows -.

- Disconnect the pneumatic line - 1 - to the compressor at the following locations. Refer to => [ Disconnecting and Connecting Pneumatic Lines ] Disconnecting and Connecting Pneumatic Lines.

a = 50 mm

Installation

- Cut the pneumatic line for the new compressor according to the design of the old compressor.

- Connect the pneumatic line. Refer to=> [ Disconnecting and Connecting Pneumatic Lines ] Disconnecting and Connecting Pneumatic Lines.

Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and Testing Procedures ] Description and Operation.

Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

Observe all measures when installing the multi-contour seat. Refer to => [ Multi-contour Seat ] Multi-Contour Seat.

Install in reverse order of removal. Note the following:

The rubber buffer must not be installed under tension or twisted.

Information for installation: for example tightening specifications, replacing body parts, refer to => [ Pneumatic Components on the Multi-contour Seat Assembly Overview ] Pneumatic Components on the Multi-Contour Seat Assembly Overview.