Distance Regulation Control Module (J428) Clip
Distance Regulation Control Module (J428) Clip
• If the stud bolt is being removed, then the clip must always be replaced.
• The clip will get damaged when it is being removed.
• The distance regulation control module and distance regulation control module 2 (J850) are removed and the nuts are removed from the stud bolts.
- Remove the stud bolt - 1 - with a suitable tool - 2 -.
- Place a screwdriver between the hook and the housing.
- Using the screwdriver, bend the hook to the center point until it audibly breaks off.
• Repeat this until all the hooks are broken.
- To prevent the broken hooks from getting caught on the housing, remove them using needle nose pliers.
- Remove the clip with needle nose pliers as illustrated.
- Insert the new clip into the hole for the housing from the left side and push it in by hand until it audibly engages.
• Make sure the tabs are lined up correctly.
- Mount the stud bolt making sure it is parallel to the hole.
- The stud bolt can be tighten once is it correctly aligned.
- Install the stud bolt until the dimension - a - is reached.
Dimension - a - = 43.3 mm (1.7 inches)
- Repeat this on the other clips.
- Install the ACC sensor for the adaptive cruise control sensor into the bracket and adjust it. Refer to => [ Adaptive Cruise Control Sensor, Adjusting ] Service and Repair.