Level Control System Control Module (J792)

Level Control System Control Module (J792)

Assembly Overview






1 Nut: 2.5 Nm

2 Bolt: 8 Nm

3 Active steering control module (J792)

4 Connector, clipped to the wiring harness

5 Ground cable

6 Bracket

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1783)

Removing

• The module is located in the footwell in front of the driver seat.

• If the module is replaced, then the program must be started on the vehicle diagnostic tester in Guided Functions.

- Loosen the driver seat and push it to the rear with the wires still connected.

- Remove the floor mat.

- Remove the sill panel strip.

- Remove the foot rest.

- Disengage the floor covering and push it to the side.

- Remove the night vision system control module (J853) E-box from the stud bolts, if equipped.

- Remove nuts - 6 -.






- Remove the nuts - 1 - and remove the ground wire - 2 - from the threaded pin.

- Carefully disconnect the wiring harness clip connection - 3 - from the bracket - 4 -.

- Remove the bolts - 5 - from the control module - 7 - and remove the bracket - 4 -.

- Disconnect the wiring harness connector - 3 - from the control module - 7 -.

Installing

Install in reverse order of removal.

Follow the sequence when installing the control module:

- Attach the bracket - 4 - to the control module - 7 - with the bolts - 5 -.






- Connect the wiring harness connectors - 3 - to the control module - 7 -.

- Carefully slide the wiring harness clip connection - 3 - into the bracket - 4 -.

- Insert the control module with the bracket.

- Connect the ground wire - 2 - to the threaded pin and tighten the nuts - 1 -.

- Tighten nuts - 6 -.

- If equipped, place the night vision system control module E-box with the 2 pins into the seat crossmember and place the front retainer over the stud bolt.

- The basic setting must be made if the active steering control module is replaced. Refer to => [ Dynamic Steering Basic Setting ] Dynamic Steering Basic Setting.