Rear Peripheral Camera (R246)

Rear Peripheral Camera (R246)

The rear peripheral camera is inside the rear lid handle. It is permanently attached to the button.

If the rear peripheral camera must be replaced, then the handle button must also be replaced.

- Turn off the ignition and all electrical consumers and remove the ignition key.

Removing

The rear peripheral camera has a trailing cable pig tail. The vehicle wiring harness couplings are located in the rear lid.

- Remove the rear lid trim panel..

- Unlock and disconnect the connectors - 2 - and - 3 - inside the rear lid and from the button in the handle - 1 -.






The rear peripheral camera is attached to the handle button - 1 -.

- Remove nuts - 1 - and - 2 -.






- Remove the handle button - 4 - with the rear peripheral camera from the mount - 3 - in the rear lid.

Installing

- Install in reverse order of removal.

- Close the rear lid.

The rear peripheral camera must be programmed again prior to calibrating if it was replaced.

Use the Vehicle Diagnostic Tester.

- Perform a calibration. Refer to => [ Peripheral View Camera System, Calibrating ] Peripheral View Camera System, Calibrating.

Component location overview for the tightening specification and installation instructions refer to => [ Peripheral View Camera System Component Location Overview ] Peripheral View Camera System Component Location Overview.