Fuel Tank Leak Detection Control Module (J909)

Fuel Tank Leak Detection Control Module (J909)

Removing






- Follow all safety precautions. Refer to => [ Safety Precautions ] Safety Precautions.

- Follow the guidelines for clean working conditions. Refer to => [ Clean Working Conditions ] Clean Working Conditions.

Danger of causing damage to other electronic components when disconnecting the battery.

• Complete the steps for disconnecting the battery.

- Disconnect the Ground (GND) cable - 2 - from the battery.

- Remove the right rear underbody panels..

- Disconnect the connector - 1 -.






- Remove the nuts - 2 and 4 - and remove the fuel tank leak detection control module - 3 -.

Installing

Install in reverse order of removal. Note the following:

• Tightening specification, refer to => [ Evaporative Emission Canister System Overview ] Service and Repair.

- Connect the battery. Be sure to read the procedures after connecting the battery.