Wiring Guide

Wiring Guide

Removing






- Remove spreader clips - 1 - by carefully pressing the clamping pin in approximately 5 mm until it audibly engages in the spreader clip.

- Open retaining tab for the wiring guide by releasing - arrow - retaining tabs using a screwdriver.

- Press the wiring guide - 2 - slightly downward and detach at the top of the rear lid hinge trim.

- Pull wiring guide up and remove it.

Installing

Install in reverse order of removal. Note the following:

Installation note: For example tightening specifications, replace components. Refer to => [ Rear Lid Trim Assembly Overview ] Rear Lid Trim Assembly Overview.