Operation CHARM: Car repair manuals for everyone.

Backrest Cover with Backrest Cushion for Multi-contour Seat







Backrest Cover with Backrest Cushion for Multi-contour Seat

Removing

- Remove the headrest. Refer to => [ Power Headrests ] Power Headrests.

Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and Testing Procedures ] Description and Operation.

Before handling pyrotechnic components (for example, disconnecting the electrical connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

- Remove the front seat. Refer to => [ Standard Seat ] Standard Seat.

- Attach front seat to the fixture for seat repair (VAS 6136). Refer to => [ Installing Front Seat on Fixture for Seat Repair VAS 6136 ] Installing Front Seat on Fixture for Seat Repair VAS 6136.

- Remove backrest. Refer to => [ Backrest ] Backrest.

- Detach hooks - 2 - and molding - 3 - of the backrest cover - 1 - at the backrest frame.






- Disconnect and free up the electrical connectors.

- Detach hooks - 1 - and molding - 2 - for the backrest cover - 3 - at the backrest frame.






- Repeat on the opposite side.

- Remove the bolts - 3 -.






- Release electrical wire bracket - 4 - for side airbag on the backrest frame.

- Push side airbag - 1 - up - arrow - and detach from the backrest frame.

- Remove side airbag from the pocket - 2 - and hook it back into the backrest frame.

- Unclip upper retaining strip - 2 - on the backrest cover - 3 - from the upper backrest adjustment pressure distribution plate - 1 -.






- Unclip backrest cushion from the upper backrest adjustment pressure distribution plate - arrow -.

- Disconnect the connector - 3 -.






- Push massage mat valve block - 4 - up slightly to detach it at the module carrier - arrow A -.

- Carefully release locking mechanism - arrow B -, disconnect pneumatic lines - 1 - and - 2 -.

- Repeat the procedure on the opposite side of the backrest.

- Detach left and right molding - 1 - on the backrest frame - 2 -.






- Free up valve block with connected pneumatic lines on the backrest frame and remove backrest cover and backrest cushion.

Installing

Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and Testing Procedures ] Description and Operation.

Before handling pyrotechnic components (for example, connecting the electrical connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

Observe all measures when installing the front seat. Refer to => [ Standard Seat ] Standard Seat.

Install in reverse order of removal. Note the following:

Installation note: For example tightening specifications, replace components. Refer to => [ Backrest Cover with Backrest Cushion for Multi-contour Seat ].