Multicontour Seat Compressor Bonded Rubber Bushing

Multicontour Seat Compressor Bonded Rubber Bushing

Special tools, testers and auxiliary items required

• Drill

• Protective eye wear

Removing

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and Testing Procedures ] Description and Operation.

• Before handling pyrotechnic components (for example, disconnecting the electrical connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

- Compressor, removing. Refer to => [ Compressor Multicontour Seat Compressors V439/V440 ] Compressor Multicontour Seat Compressors V439/V440.

- Remove the bracket for the front trim, the compressor and the multicontour seat control module. Refer to => [ Front Trim Bracket, Compressor and Multicontour Seat Control Module ] Front Trim Bracket, Compressor and Multicontour Seat Control Module.








Eye injury risk.

• Wear protective eye wear!

- Drill out rivets - arrows - and remove compressor.

Installing

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and Testing Procedures ] Description and Operation.

• Before handling pyrotechnic components (for example, connecting the electrical connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

• Observe all measures when installing the front seat. Refer to => [ Standard Seat ] Standard Seat.

Install in reverse order of removal. Note the following:

• The rubber-metal compress mount must not be installed under tension or twisted.

• Therefore, first bolt all rubber-metal mounts to the compressor. Refer to and then rivet them.