2-Pin Relay/Fuse Panel, Right A-pillar

2-Pin Relay/Fuse Panel, Right A-pillar

Removing






- Turn off the ignition and disconnect the ground cable from the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove the front sill panel..

- Remove the nuts and disconnect the wires - 1 - and - 2 -.

- Remove bolt - 1 -.






- Disconnect the connectors - 2 - and - 3 -.

- Open the clip and remove the auxiliary fuse panel - 3 -.






- Open the clip - 2 - and remove the connector - 1 -.

• The exact assignment of the 2-pin relay/fuse panel on the right A-pillar can be found in the applicable wiring diagram.

Installing

• For the correct tightening specification, refer to => [ Relay Carrier and Fuse Panel in Instrument Panel and A-Pillar Overview ] Relay Carrier and Fuse Panel in Instrument Panel and A-Pillar Overview.

Install in reverse order of removal. Note the following:

- Install the front sill panel..

- Connect the battery. Required actions, refer to=> [ Connecting ] Battery, Disconnecting and Connecting.